/
Set connection interface as default [1]
Set connection interface as default [1]
Set connection interface as default
Friday, September 10, 2004 12:27 AM - MFMurphy00
I have two Ethernet interfaces, either of which can be used to connect to the XDMCP server on the network. Using V2 of XManager I am presented with a dialog box asking me to choose which interface to use for the connection. How do I set up for XManager to use one without asking (preferred) or to set the default to a particular one ( acceptable) since the default is the one I prefer *not* to use (wireless) if I have a hardwire connection?
Re: Set connection interface as default
Monday, September 13, 2004 5:25 PM - Support
You can bind a specific IP address to a session as following:
1. Run Xbrowser.
2. Right-click on the host you want to connect to.
3. Click Save As. Result: A new session is created.
4. Double-click the new session.
Now, you will be able to enable the "Always use this address" check box on the IP selection dialog box.
----
Technical Support
1. Run Xbrowser.
2. Right-click on the host you want to connect to.
3. Click Save As. Result: A new session is created.
4. Double-click the new session.
Now, you will be able to enable the "Always use this address" check box on the IP selection dialog box.
----
Technical Support
Previous views: 142
, multiple selections available,
Related content
IP Selector [1]
IP Selector [1]
More like this
System Administrator [3]
System Administrator [3]
More like this
Command line parameters for XDMCP connections
Command line parameters for XDMCP connections
More like this
Xmanager server Command Line Options
Xmanager server Command Line Options
More like this
Xmanager server Command Line Options
Xmanager server Command Line Options
More like this
How to set up connection address for Secure XDMCP
How to set up connection address for Secure XDMCP
More like this